PART VIII MACHINERY AND EQUIPMENT — Powder actuated tool use
106
(1) A low velocity powder actuated tool, with a fastener test speed rating of less than 100 metres a second, shall be used unless no low velocity tool available on the market is capable of doing the fastening task.
106(2)
Two separate and distinct operations shall be required to activate a powder actuated tool and the final firing movement shall be separate and subsequent to depressing the tool into the firing position.
106(3)
A powder actuated tool shall be designed so that positive means of varying the power level is available, or can be made available, to enable the operator to select a power level appropriate to perform the desired work.
106(4)
A powder actuated tool shall be marked with the manufacturer's name or trademark, model number and serial number.
106(5)
When not in use, a powder actuated tool shall be unloaded and the tool and power loads shall be securely stored and be accessible only to qualified and authorized persons.
106(6)
Powder loads of different power levels and types shall be kept in different compartments or containers.
106(7)
A worker shall not operate a powder-actuated tool until the worker
106(a)
has been trained in the use of the specific make and model of tool and is in possession of a valid operator's certificate issued by the manufacturer or other qualified instruction agency; a copy of the manufacturer's operating instructions for the tool;
106(b)
has demonstrated that the worker can use the tool effectively and safely; a copy of the powder load and fastener charts for the tool; and
106(c)
is familiar with these regulations; accessories or tools needed for use or field servicing of the tool, including personal protective equipment.
106(d)
has been authorized by the worker’s supervisor to use the tool; and
106(e)
is wearing the personal protective equipment required by sections 70 to 86 .
106(8)
When using or servicing a powder-actuated tool, an operator shall have immediately available
106(9)
A powder-actuated tool shall not be used in an explosive or flammable atmosphere.
106(10)
A powder-actuated tool may only be loaded where it is being prepared for immediate use, and shall be unloaded at once where work is interrupted after loading.
106(11)
A powder-actuated tool shall not be pointed at a person.
106(12)
Where a powder-actuated tool misfires, the operator shall hold the tool firmly against the work surface for at least 5 seconds, then follow the manufacturer's instructions for those occurrences and, until the cartridge has been ejected, keep the tool pointed in a direction that cannot cause injury to a person.
Not legal advice. Verify the cited article against the signed agreement.